Knitted Coat Hanger Creation

By Spotlight

Spice up your wardrobe.

Final Result

Materials

• 40m (1/2 pack) UNITRIM Knitlon Knitting Nylon
• 3m Eyelet Lace
• 1 pair 30cm x 4.00mm Knitting Needles
• 1 Knitters Needle
• 30cm x 6mm Krafty Savers Ribbon
• 1 Adult size Wooden Coat Hanger

Step 1

Coat Hanger Cover

Cast on 68 stitches.
Knit 2 rows Garter (Plain) stitch.
* Knit 1 row adding Eyelet lace*.

To insert - Hold lace at back of work.
Insert the needle into the stitch and into hole in middle of lace.

Work as usual, repeat to end of row.

Knit 5 rows Garter stitch
Repeat Steps *2 to 3* x 2 more times. *(3 in total).
Knit 2 rows Garter stitch.
Cast off leaving a 30cm length for sewing.

Step 2

To Make Up Coat Hanger

Remove the hook from hanger.
Mark centre with a pin.
Hold the casing onto coat hanger and using knitters needle sew together the underside edges.

Step 3

Hook Cover

Cast on 20 stitches.
Knit 2 rows Garter stitch.
Knit 1 row adding lace.

(Insert in the same way as per coat hanger cover).

Knit 2 rows Garter stitch.
Cast Off.

Step 4

To Make Up Hook Cover

Hold casing edges together and commence to sew using knitters needle.

Slip hook in and finish sewing.
Insert the hook into the hanger at centred pin mark.

Fasten off by sewing ends down to casing.

Step 5

To Complete

Tie a length of 30cm x 6cm Krafty Savers Satin Ribbon around the base of the Hook.
Tie into a bow to finish.

Note

1 roll of UNITRIM Knitlon will cover 2 adult size coat hangers.

We used UNI-TRIM Knitlon for the best results.